No announcement yet.

Parting out my 445rwkw 7MGTE Z21

  • Filter
  • Time
  • Show
Clear All
new posts

  • Parting out my 445rwkw 7MGTE Z21

    It is with much sadness that i have decieded to part out my soarer due to non use and it is now in the way.

    Everything will be available once I have commitments for the initial 'easy' to remove parts listed below.

    This package made 445rwkw - not bad for a tractor motor.

    At this stage the following is for sale before commiting to more parts:

    - Autronic SM4 ECU with loom setup for 7MGTE - $1500

    - SARD 700cc Injectors x 6 - $500

    - 7MGTE Intake Package (Bolt on solution) - Custom JMR Front Facing Aluminium Inlet Plenum (approx 3.1L), including Edelbrock 75mm Butterfly Throttle Body, SV21 Camry throttle cable, alternator relocation bracket and belt. - $500

    - 7MGTE Hot Side Package (sold together as a package) - TRUST TD-07S-25G Turbo (Rebuilt April 06 with GT40 impellor wheel) sitting on Genuine HKS T04 Cast short runner exhaust manifold and Genuine HKS 50mm Racing External Wastegate (22.8psi Spring) - $1500

    - 7MGTE Custom 3.5" Turbo Back Stainless Steel Exhaust, plumbed in external wastegate, with 5" Cat Convertor & no rear muffler (straight pipe) (Suit A70/Z20) - $800

    - A70/Z20 Big brake kit - Ford Falcon BA GT PBR Twin Piston Calipers with Ford Falcon BA GT-P 355x30mm front rotors and EBC Greenstuff pads will also throw in Goodridge Stainless Steel Brake Lines x4 - $1000

    - OS Giken TS2CD twin plate clutch and flywheel - $1000

    - R154 Manual conversion, box has upgraded thrust washer. Will include tails haft, pedal box, clutch master and slave - $2000

    - 7MGTE long motor - Engine: 7M-GTE ('The Megap00')

    HKS 85.5mm forged pistons

    Eagle H beam rods

    Cryotreated and nitrided crank

    Significantly Ported Head (Cast #11)

    Custom made TED components billet cams (272 x 8.9mm lift)

    Ferrea 1mm oversize s/s valves

    Double valve springs

    Titanium retailers

    ATI cam gears

    New oil and water pumps

    ARP fasteners throughout

    Clevite Nascar series bearings

    Cometic MLS Head Gasket

    HPC coated 7MGE cam covers with speedflow fittings

    Custom winged sump with increased capacity and trap doors

    Run in and tuned on the dyno at SAS and has seen one track day and one dyno day since.

    Will suit a quick tear down as hasn't been started in 2 years. - $2500

    Located Sydney - Pickup prefered option

  • #2
    Message Sent


    • #3
      Hey mate real keen! Planing on going down to Sydney next week, my phone number is 0478218910 call me!


      • #4
        Hey, what's your interior like, are you selling any of those parts?